Ashland I-155XL2 Ver 7-2008 User Manual download pdf (Page 20)

I-155 XL2

Troubleshooting

TROUBLESHOOTING

Introduction

With proper care and maintenance, the I-110TS will give many years of reliable service. When a situation

arises where the earthmover performance is not satisfactory, this section will give some pointers on finding

and correcting the problem.

Grease zerk will not take grease.

1. Grease zerk plugged.

a) Remove and replace grease zerk.

2. Pin is frozen.

a) Remove, clean, and inspect pin.

b) Replace pin if necessary.

3. Bushing grease passage is not aligned with grease zerk.

a) Remove, clean, inspect, and realign bushing.

b) Replace bushing if necessary and realign.

Push-off rollers do not roll.

1. The rollers need lubrication.

a) Check zerk hole and grease.

b) Remove pin, clean, inspect, and replace if necessary.

2. The roller bushing is worn out.

a) Remove roller assembly and replace bushing.

b) See parts manual.

Cylinders will not hold in preset position, i.e. the cylinder creeps.

1. Seals leaking internally.

a) Remove and replace seal kit.

Machine cuts unevenly.

1. Cutting edges worn unevenly.

a) Replace cutting edges.

2. Improperly inflated tires.

a) Check air pressure in tires.

Ashland Industries Troll-free:877-634-4622 Fax:715-682-9717

Page #19

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Ashland I-155XL2 Ver 7-2008 User Manual Page 20